You are here:Home>E

Prompt: Error executing Flow80.exe at Path

The first time I start ProcessModel I get an error saying it can't execute iGrafx or Flow80.exe. ProcessModel 5.x and earlier versions, use iGrafx as the front end of the application. Therefore, if you have any iGrafx software already installed on your computer there will be conflicts with the version which ProcessModel installs and uses. If you [...]

By |Categories: , |Comments Off on Prompt: Error executing Flow80.exe at Path

Entity Exits System Before Releasing

During the simulation run the following message is received: (Error,Entity exits system before releasing all captured resources!) Reason: A resource was captured using a Get or JointlyGet statement but not Free'd before exiting. The entity left the system with a resource still attached. The engine recognizes this as an error because the model will soon [...]

By |Categories: |Comments Off on Entity Exits System Before Releasing

Missing ‘)’ in Expression

When I place an action logic line that contains the word TIME (e.g. VATIME) before my actual TIME statement, I get an error saying “Missing ')' in expression”. This error is caused by a very specific set of conditions. You must have an action logic line that contains the word TIME (e.g. v_CheckTime) That same line [...]

By |Categories: , |Comments Off on Missing ‘)’ in Expression

Else is a Reserved Word

When using a single FREE command in my If – Then block I get the error “Else is a reserved word” even though my action logic syntax appears to be correct. When using FREE statements in an If – Then or If – Then – Else block, subroutines are being called by the system to [...]

By |Categories: |Comments Off on Else is a Reserved Word